Westinghouse Fan WST6003 User Manual

WST6003 Flat Fan Heater  
 
11. To prevent a possible fire, do not block air intakes or exhaust in any  
manner. Do not use on soft surfaces, like a bed, where openings may  
become blocked. Use the Heater on flat, dry surfaces only.  
12. A Heater has hot and arcing or sparking parts inside. Do not use it in  
areas where gasoline, paint, or flammable liquids are used or stored.  
13. Use this Heater only as directed in this manual, Any other use not  
recommended by the manufacturer may cause fire, electric shock, or  
injury to persons.  
14. Avoid the use of an extension cord because the extension cord may  
overheat and cause risk of fire. However, if you must use an extension  
cord, the cord shall be #14 AWG minimum size and rated not less than  
1875 watts.  
15. If the Heater will not operate: See specific instructions on Auto Safety  
Shut Off.  
16. Do not place the Heater on an uneven or small surface which might  
allow it to tip or fall.  
17. Do not operate the Heater with Heater Guards removed.  
18. The Heater must be 12 inches (300mm) distance away from the wall or  
other objects.  
19. This Heater includes a visual alarm to warn that parts of the Heater are  
getting excessively hot. If the alarm flashes, immediately turn the Heater  
OFF and inspect for any objects on or adjacent to the Heater that may  
cause high temperatures. DO NOT OPERATE THE HEATER WITH THE RED  
SAFETY LIGHT FLASHING .  
SAVE THESE INSTRUCTIONS  
FOR HOUSEHOLD USE ONLY  
2
 
ADDITIONAL IMPORTANT SAFEGUARDS  
CAUTION HOT SURFACES: This Heater generates heat during use. Proper  
precautions must be taken to prevent the risk of burns, fires or other  
injury to persons or damage to property.  
CAUTION: This Heater is hot during operation and retains heat for some time  
after turning OFF. Do not place anything on top of the Heater while it is  
operating or while it is hot.  
1. A person who has not read and understood all operating and safety  
instructions is not qualified to operate this Heater. All users of this  
Heater must read and understand this Owner’s Manual before operating  
or cleaning this Heater.  
2. Unplug Heater from outlet and allow to cool before attempting to  
store unit.  
3. The cord to this Heater should be plugged into a 120V AC electrical  
outlet only.  
4. Do not use this Heater in a garage.  
5. When using this Heater, provide adequate air space above and on all  
sides for air circulation. Do not operate this Heater while it is touching  
or near curtains, wall coverings, clothing, dish towels or other  
flammable materials.  
6. Use this Heater only on a level surface.  
7. Do not operate Heater when the Red Safety Light is flashing.  
Polarized Plug  
This appliance has a polarized plug (one blade is wider than the other). To  
reduce the risk of electric shock, this plug is intended to fit into a polarized  
outlet only one way. If the plug does not fit fully in the outlet, reverse the  
plug. If it still does not fit, contact a qualified electrician. Do not attempt to  
modify the plug in any way.  
Electric Power  
If the electrical circuit is overloaded with other appliances, your appliance  
may not operate properly. It should be operated on a separate electrical  
circuit from other appliances.  
3
 
Getting To Know Your Westinghouse  
WST6003 Flat Fan Heater  
Product may vary slightly from illustrations  
Air Intake  
(not shown)  
Thermostat  
Dial  
Heater/  
Fan Dial  
Red Safety  
Light  
Amber Power  
ON/OFF Light  
Front  
Safety Grill  
OFF Fan  
LO  
Top Grill  
HI  
Heater/Fan  
Dial  
MIN  
Thermostat Dial  
MAX  
Amber Power  
ON/OFF Light  
Red Safety  
Light  
4
 
BEFORE USING FOR THE FIRST TIME  
Your WST6003 Flat Fan Heater is designed for space heating or as a  
supplementary heat source. It is not intended to be the main source of heat.  
NOTE: Make sure the Heater Dial is in the  
OFF position before operating.  
1. Place your Heater on a level, stable surface. It is recommended that the  
Heater be placed on the floor, where it can keep the lower level of the  
room warm. Be sure the sides and back of the Heater are at least 3 feet  
away from any combustible materials. DO NOT COVER the Air Intake or  
the Front Safety Grill.  
2. Plug the Flat Fan Heater into a 120V AC electrical outlet.  
3. There are 3 settings on the Heater Dial:  
Fan / Breeze Fan only LO Heat / 750 Watts HI Heat /1500 watts  
OPERATING INSTRUCTIONS  
Setting the Thermostat for Heat  
1. When heating a cold area in the room, first turn the Thermostat Dial to  
the MAX position.  
2. Next, turn the Heater Dial to either LO or HI Heat.  
3. The amber Power ON/OFF Light will illuminate when you turn the  
Heater Dial from the OFF position. The Fan will begin to rotate.  
Your Heater will quietly and efficiently heat your area.  
4. When the desired temperature is reached, turn the Thermostat Dial  
counter-clockwise to a lower setting until the Fan turns itself OFF.  
5. The temperature is now pre-set.  
6. When you are finished using the Flat Fan Heater, turn the Heater/Fan  
Dial to the OFF position, turn the Thermostat Dial to the minimum  
setting, and unplug from the electrical outlet.  
NOTE: The Heater will cycle ON and OFF to maintain this temperature.  
This is normal.  
NOTE: To prevent the Heater from cycling, turn the Thermostat Dial to a  
lower setting.  
5
 
WARNING: The red Safety Light will serve as a visual alarm to alert you that  
the thermal cut-off is broken. At this time, the Heater will turn itself OFF.  
If both the red and the amber Lights are illuminated, immediately turn the  
Heater/Fan Dial to the OFF position, turn the Thermostat Dial to MIN and  
unplug the cord from the electrical outlet. (See Auto Safety Shut Off  
section of this manual for more information.)  
Setting the Thermostat for Breeze Fan Only  
1. You may use your Heater Fan to create a comfortable breeze by  
circulating air only. When using the Fan, first turn the Thermostat Dial  
to the MAX position.  
2. Next, turn the Heater Dial to Fan.  
3. The amber Power ON/OFF Light will illuminate when you turn the  
Heater Dial from the OFF position. The Fan will begin to rotate.  
Your Heater will quietly and efficiently provide a cool and comfortable  
breeze to your area.  
4. When the desired temperature is reached, turn the Thermostat Dial  
counter-clockwise to a lower setting until the Fan turns itself OFF.  
5. The temperature is now pre-set.  
6. When you are finished using the Flat Fan Heater, turn the Heater Dial to  
the OFF position, turn the Thermostat Dial to the minimum setting,  
and unplug from the electrical outlet.  
NOTE: The Heater will cycle ON and OFF to maintain this temperature.  
This is normal.  
NOTE: To prevent the Heater from cycling, turn the Thermostat Dial to a  
lower setting.  
6
 
Frost Watch  
If your Heater is plugged in and in operation and set at the lowest setting  
(the Heater/Fan Dial set to LOW and the Thermostat Dial set to MIN) the  
Heater will remain OFF unless the temperature drops below 41ºF. At 41ºF  
the Heater will automatically turn ON and will cycle ON and OFF to keep the  
area at a constant temperature.  
Auto Safety Shut Off  
When the temperature rises to an unsafe level, usually due to an obstruction  
of the Front Safety Grill or Air Intake, the red Safety Light will illuminate and  
the Heater will turn itself OFF. Immediately turn the Heater/Fan Dial to the  
OFF position, turn the Thermostat Dial to LOW. Remove the plug from the  
outlet and allow the Heater to cool for 30 minutes. If necessary, remove the  
object causing the problem; then plug into the outlet and turn the  
Heater/Fan Dial. If the Heater’s red Safety Light is still illuminated, call  
Consumer Service for authorization for return or repair.  
DO NOT USE A MALFUNCTIONING HEATER.  
7
 
USER MAINTENANCE INSTRUCTIONS  
This appliance is permanently lubricated and will not require additional  
lubrication for the life of the unit. There are no user serviceable parts inside  
the unit. Servicing by our Authorized Service Center is required to avoid  
damage to internal components.  
Cleaning  
Always turn the Heater/Fan Dial to the OFF position, turn the Thermostat  
Dial to LOW and unplug from the electrical outlet before cleaning your  
Heater. Accumulated dust may be removed from the Heater with a soft cloth  
or vacuum cleaner using the dusting brush attachment. Interior dust can  
often be removed by using a vacuum cleaner in its blower mode with a  
crevice attachment.  
Your Flat Fan Heater may also be cleaned with a cloth that has been  
moistened with a solution of mild detergent and water. Dry the outside of  
the unit thoroughly with a soft, dry cloth before operating.  
CAUTION: DO NOT immerse Heater in water or allow water to drip into  
the Heater housing, as this could create an electric shock hazard.  
NEVER use gasoline, benzene, thinner, etc., as these chemicals will  
damage the unit.  
Storage  
1. Allow Heater to cool before storage. Never store the Heater while it is  
hot or still plugged in.  
2. Gather the cord in loops and secure with a twist tie to store. Never let  
the power cord come in contact with sharp edges or get compressed by  
heavy objects.  
3. Never wrap cord tightly around appliance. Do not put any stress on cord  
where it enters the unit, as this could cause cord to fray and break.  
4. Store the Heater in its box or in a clean, dry place.  
8
 
LIMITED ONE-YEAR WARRANTY  
Warranty Coverage: This product is warranted to be free from defects in materials or  
workmanship for a period of one (1) year from the original purchase date. This product warranty is  
extended only to the original consumer purchaser of the product and is not transferable. For a period  
of one (1) year from the date of original purchase of the product, our Repair Center will, at its  
option, either (1) repair the product or (2) replace the product with a reconditioned comparable  
model. These remedies are the purchaser's exclusive remedies under this warranty.  
Warranty Service: To obtain warranty service, you must call our warranty service number at  
1-800-233-9054 for return instructions on how to deliver the product, in either the original  
packaging or packaging affording an equal degree of protection to the Repair Center specified  
below. You must enclose a copy of your sales receipt or other proof of purchase to demonstrate  
eligibility for warranty coverage.  
To return the appliance, ship to:  
To contact us, please write to, call, or email:  
ATTN: Repair Center  
708 South Missouri Street  
Macon, MO 63552 USA  
Consumer Relations Department  
PO Box 7366  
Columbia MO 65205-7366 USA  
1-800-233-9054  
E-mail:consumer_[email protected]  
What Is Not Covered: This warranty does not cover damage resulting from misuse, accident,  
commercial use, improper service or any other damage caused by anything other than defects in  
material or workmanship during ordinary consumer use. This warranty is invalid if the serial number  
has been altered or removed from the product. This warranty is valid only in the United States and  
Canada.  
LIMITATION ON DAMAGES: THERE SHALL BE NO LIABILITY FOR ANY INCIDENTAL OR  
CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY OR CONDITION  
ON THIS PRODUCT.  
DURATION OF IMPLIED WARRANTIES: EXCEPT TO THE EXTENT PROHIBITED BY  
APPLICABLE LAW, ALL IMPLIED WARRANTIES AND CONDITIONS, INCLUDING, WITHOUT  
LIMITATION, IMPLIED WARRANTIES AND CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A  
PARTICULAR PURPOSE OR USE ON THIS PRODUCT ARE LIMITED IN DURATION TO THE DURATION  
OF THIS WARRANTY.  
Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages,  
or allow limitations on how long an implied warranty lasts, so the above limitations or exclusions  
may not apply to you. This warranty gives you specific legal rights and you may have other rights  
under the laws of your jurisdiction.  
WESTINGHOUSE, and “You Can Be Sure...If It's Westinghouse” are trademarks  
of WESTINGHOUSE ELECTRIC CORPORATION and used under license.  
©2005 All rights reserved. Patent Pending  
Made in China  
P/N 61712  
6/05  
 

Weed Eater Tiller 162893 User Manual
Weslo Treadmill WLTL39092 User Manual
West Bend Back to Basics Blender Smoothie Professional User Manual
Westinghouse Indoor Furnishings W 107 User Manual
Whirlpool Dryer Accessories WTW5600SQ0 User Manual
Whirlpool Range 98012565 User Manual
Xantech Stereo System MRAUDIO8X8M User Manual
Xyron Laminator FPO User Manual
Yamaha CD Player CRW8824E User Manual
Zenith Projection Television R49W36 User Manual